XADO VitaFlush is an engine flush that cleans the inside of your engine just before an oil change. You add it to the old oil, run the engine briefly, then drain. It contains Revitalizant, which protects the moving parts while the cleaning takes place.

An oil change does not remove everything. When the old oil drains out, a good part of what it was carrying stays behind: sludge in the corners of the sump, sticky varnish on the pistons, carbon packed around the piston rings. Fresh oil goes in, picks all of that up within the first few kilometres, and is dirty again before it has done any real work.

VitaFlush clears the way first. Added to the warm old oil, it loosens the deposits and holds them in suspension, so they leave the engine when the oil is drained. It works in 10 to 30 minutes.

A clean engine is a better engine. Piston rings that were stuck in carbon move freely again and seal properly. Noisy hydraulic tappets quieten down. The breather system clears, and the oil pump can deliver proper pressure. Your new oil starts its life in a clean engine and protects it for longer.

It contains no acids, acetone or harsh solvents, so it is gentle on seals and safe for catalytic converters.

Why drivers choose it

It cleans the whole oil system of sludge, varnish and carbon. It frees sticking piston rings. It quietens sticking hydraulic tappets. It cleans the crankcase breather system. It helps steady the oil pressure. And it is compatible with every type of oil and safe for rubber seals, oxygen sensors and catalytic converters.

Made for engines like yours

Any petrol or diesel engine, turbocharged ones included: saloons, 4x4s, pickups, vans and trucks. It can also be used to clean manual gearboxes before a gear oil change.

It is especially worth using when you have bought a used car and do not know its service history, when a service is overdue, when you are switching to a different type or brand of oil, such as mineral to synthetic, or when the engine has started to use oil or sound rough.

For the best results, use it at every oil change. If you are not sure whether your engine needs a normal or an intensive clean, our specialists can advise.

Genuine XADO, straight from the source

Every can we sell comes directly from XADO and arrives sealed. If you would rather not do the oil change yourself, our Nairobi service centre can do the flush and the change together.

Fresh oil deserves a clean engine. Give it one.

How to use

Use VitaFlush just before an oil change, with the old oil still in the engine.

Warm the engine up, switch it off and pour VitaFlush in through the oil filler cap. For regular use, add 60 ml for every litre of oil, so one 250 ml can treats an engine holding about 4 litres. For a heavily contaminated engine, add 100 ml for every litre of oil.

Start the engine and let it idle for 10 to 15 minutes, or drive about 20 km. For intensive cleaning of a badly contaminated engine, you can drive 200 to 300 km before draining.

Then drain the oil while it is warm, fit a new oil filter and fill with fresh oil. Always change the oil and filter after using VitaFlush.